How To Tile A Bay Window Roof
Fine Homebuilding Project Guides
Framing
How-To
Bay-Window-Roof: Final Installation
One time the bay window is in identify, it'southward time to secure, insulate, and sheathe the roof unit.
To prep the rough opening, the showtime thing we wanted to do was make sure the sill was straight and apartment. The other affair was to put flashing tape around the bottom and the sides also. Nosotros took the sash out of the window to make information technology lighter and easier to carry. If you spend a lilliputian extra time on the staging, the job goes easier. The goal was to get a couple of tiers here: 1 low so that we tin pace the window up, with the terminal top tier being even with the rough opening. Once the bay window is upwardly on the acme tier of the staging, nosotros can slide information technology right into the rough opening without a problem. Because the top plank is going to bend a niggling bit with the weight, we accept a couple of shims handy that nosotros can shove right under in that location. Screws are temporary until nosotros tin become the sash back in place. Once the sash is in place, we level and plumb information technology, and put the permanent fasteners in place all the way effectually the within.
The insulation is very of import-and it'southward very like shooting fish in a barrel. Earlier nosotros put the roof assembly down, we put 1 inch of rigid insulation. Information technology acts every bit a expert insulating bulwark and thermal break. Merely before we put the roof unit in place, it's critical to go the housewrap up and out of the roof area. The last thing we want is housewrap behind the roof we're putting on. We're measuring straight in-4½.
Now that nosotros have the window in place, it's plumb, level, and square. Long ago, to keep it from sagging, nosotros used to put giant brackets underneath to agree it in place. Instead of doing that, we now use a manufacturer's cable support system. The way it works is I'm going to feed this down through the peak, and it's going to fasten underneath, at the bottom, at both outside points. The cables come up up, and we're going to securely spike them to the walls. This will continue the front end of the window from sagging over time. Now that the cablevision is in nice and tight, the next pace is to insulate.
We record the seams on the roof using a zip roof system. The squeamish thing about the organisation is that yous don't need any underlayment. All you have to do is tape the seams all the fashion effectually, and once you do that, the thing is completely dried in.
Now that nosotros're dried in for the night, we'll come back tomorrow morning to cease.
The exterior is finished. A little trimwork on the inside, and I'thou washed.
Sign up for eletters today and get the latest how-to from Fine Homebuilding, plus special offers.
Previous: Bay-Window Roof: How to Install Sheathing
Source: https://www.finehomebuilding.com/project-guides/framing/bay-window-roof-final-installation
Posted by: hairstonalreend38.blogspot.com
0 Response to "How To Tile A Bay Window Roof"
Post a Comment